Gas (LPG) Leakage Detector and Alarm Built on Bolt IoT
In this project,we can be used to detect any gas leakage and give a fire alarm if any fire is detected in that area.
Hardware Required:
-
Bolt IoT
-
Gas sensor
-
Fire sensor
-
Arduino
-
Motor driver
-
Buzzer
-
Wires
-
LED
-
Breadboard
-
Switches
-
Resistors
-
Relay
Steps to Follow:
This project can be used mainly in kitchen to detect any gas leakage and give a fire alarm if any fire detected.
Step 1: Objective
Basic idea to make a device with the help of Bolt device to be able to detect any gas leakage, especially LPG in kitchens to prevent anyone to be in contact with any harmful devices. It will sound a fire alarm (buzzer) if any fire is detected.
Step 2: SOLUTION
Firstly, we have connected all the devices with the help of wires on the breadboard. The Arduino's output is given to bolt by the digital output ports. The gas and fire sensors are connected to the Arduino ports and detected with the help of LEDs. When concentration of particular gas exceeds a known threshold value, or when temperature rises abnormally beyond normal near fire sensor, the device starts its intended task. When the device senses gas leakage or fire nearby, it sends message via mobile SMS to concerned people, besides setting ON hooter and/or exhaust (in case of fire). Images of sensors (gas and fire) have been attached with this page.
Step 3: Conclusion
The device proves to be helpful in saving many lives and limit the dreadful aftermath of such unfortunate event. It could be installed in house kitchens, restaurants, offices, etc. Thus, it should prove to be a highly beneficial device.
